Do I need to cut the trace as indicated by the wiki page? How do I tell if this is from the first batch? The date on the back says Ģ. OK, I just received a new board from readytoflyquads (whitespy).ġ.
#Arduino camera with osd how to#
It will make me very happy if anyone has an idea on how to solve this upload problems, or if someone knows if i may be fine with the old "resistor modded" "Minim OSD V0.1" for now. Of course i´d prefer to use the new Minim OSD V1.1.pfffff. Just perfectīefore i let this board levitate again, i wanted to ask for some feedback, if it may theoretical be ok, also without the resistor. There was no heat up and no fading away. With the result that everything seems to work as it should. As i am afraid of this board, i left it connected to KV-GUI with simulating enabled for around an hour. Now i was shocked, this crazy thing works! I have some flickering of the OSD graphics/letters, but not disturbing at all, on my FPV screen.
Because i did not care anymore about this board and i wanted to know what happens, i just soldered a bridge instead of the resistor. Seems like its soldering contact went away.
I was not able to resolder the resistor, as it did not stick to its solderingpoints anymore. What would this resistor do for the MAX chip? It was the one that just popped out a resistor during flight and resetted my FC leading to a fatal crash. Ok, as i dont like to give up, i proceed with repairing the OSD i never intendet to use again. Its frustrating to wait for 2010293093 days (32 days ) to recieve a unit, that will not work even if price is low. Is this the only thing left to try? Any advices? So, shouldnt it have a working arduino bootloader? Burn a new bootloader, as i dont have the neccesary programmer. tested FTDI also with my FC -> everything fine
tested FTDI on my old minim osd V0.1 -> working without problems.
#Arduino camera with osd pro#
try to use all other versions of the ATMEGA 328 board instead of "Arduino Pro or Pro Mini (5v 16mhz) w/ ATMEGA 328" for upload. >now i have the "waiting for mavlink heartbeats" message on my FPV screen, so i assume the OSD is not dead. (This was mentioned in some topics across the web) connect FPV cam and transmitter, to get an additional GND. test different versions of Arduino SW 1.0-1.05 double, triple, octo check my connections. System wide configuration file is "C:\Program Files (x86)\Arduino\hardware/tools/avr/etc/nf"Īvrdude: stk500_getsync(): not in sync: resp=0x00 Code: Select all Binäre Sketchgröße: 790 Bytes (von einem Maximum von 30.720 Bytes)Ĭ:\Program Files (x86)\Arduino\hardware/tools/avr/bin/avrdude -CC:\Program Files (x86)\Arduino\hardware/tools/avr/etc/nf -v -v -v -v -patmega328p -carduino -P\\.\COM4 -b57600 -D -Uflash:w:C:\Users\Nocturn\AppData\Local\Temp\build4124390543560591445.tmp\EEPROM_:iĪvrdude: Version 5.11, compiled on at 19:38:36
0 kommentar(er)
